|
New Designz
Shocker 2003
Trigger Just
slide your finger up and down over the bumps and watch the paint fly. You
can adjust pre, post travel along with a magnet screw adjustment. The
magnet has not been glued in the screw. During the magnet installation to
the frame we have found that the magnet orientation can be 50/50. This
will allow you to set it to repel in your marker, no matter which
direction your factory magnet was installed to begin with. Custom milled
profile. Nylon tipped trigger stop set screw to stop frame wear. All
screws are stainless steel with SAE threads. Loctite (serviceable) is
pre-applied to all screws for added convenience. Wider than stock for
minimal side to side wobble. It is as wide as the trigger guard with a
rounded finger area for the ultimate in comfort. It is .375" wide. Yield
higher rates of fire with no other modification.
1401109 $34.99
$19.99 |
